COMFORT-AIRE REG-81M Manual do Proprietário descarregar pdf (Página 11)

Owner’s Manual - RADS-183P, 253P, RAD-283M, REG-183M, 253M

INSTALLATION INSTRUCTIONS

NAIL SPACERS

TO STUDS

LEVEL

Fig.3

NOTE: If wall thickness is 8-1/2 or more, add

aluminum flashing over bottom of frame opening

to assure no water can enter area between inner

and outer wall.

Caulkas

Required

Aluminum Flashing

Over Bottom Of Frame

Over

8-1/2

Fig.4

4. Build a wooden frame with the INSIDE dimen-

sions of your model listed above. (Remember

measure twice). Frame depth should be the

same as wall thickness. Fill in the space from

the opening to the studs with wood spacers,

as shown.

5. Nail frame to spacers with front flush with drywall.

Inside Frame Height: 18-7/8"(47.9cm) or18" (45.7cm)

Inside Frame Width: 26-3/4"(67.9cm) or 23-7/8"(60.6cm)

Fg.2

Frame

Height

Inside

Frame

Inside

Width

Up to 8-1/2"

B.Thru-The-Wall Installation

Select Wall Location

The air conditioner has a slide-out chassis, so

that it can be installed through an outside wall

as specified below:

Max. Wall thickness: 12 or 10

IMPORTANT: Side louvers must never be blocked.

NOTE: All parts needed for Thru-The-Wall Install-

tion are provided, except a wood frame, shims,

and 10 wood screws(#10-1 long minimum).

Select a wall surface that:

1. does not support major structural loads such

as the frame construction at ends of windows,

and under truss-bearing points, etc.

NOTE: Consult local building codes

carpenter pri

or to installation.

or a qualified

Prepare Wall

1. Prepare wall in frame construction (including

brick and stucco veneer). Working from inside

the room, find wall stud nearest the center of

area where air conditioner will be installed

(by sounding wall, or by magnetically finding

nails).

2. Cut or knock out a hole on each side of center stud.

3. Measure between inside edges of every other

stud as shown in Fig.1.

Fig.1

3-3/8" MIN

(8.6 cm)

Carefully measure and cut an opening with the

following dimensions depending on your model.

See Fig.1 and Fig.2.

WIDTH X = inside model width plus twice the

thickness of framing material used.

HEIGHT Y =inside model height plus twice the

thickness of framing material used.

2. does not have plumbing or wiring inside.

3. is near existing electrical outlets, or where

another outlet can be installed.

4. faces, and is not blocked to the area to be

cooled.

5. allows unblocked airflow from rear sides and

end(outside) of installed air conditioner.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comentários a estes Manuais

Sem comentários

COMFORT-AIRE REG-81M Manual do Proprietário Página 11

Comentários a estes Manuais